ImagePerfect™ Vinyl Remover Pro (1000 ml)

ImagePerfect™ Vinyl Remover Pro (5000 ml)

ImagePerfect™ Vinyl Remover Pro impresses with its high effectiveness and versatility. It is suitable for removing self-adhesive films, including the adhesive, from a wide variety of surfaces, such as vehicles (e.g., car wrapping), light boxes, windows, glass, plastic, boards, and coated aluminum.

Application: ImagePerfect™ Vinyl Remover Pro is ready to use immediately. Apply the product to the surface. The IP Vinyl Remover Pro penetrates the film to deactivate the adhesive and remove the vinyl along with the adhesive in a single step. To ensure the film remover works evenly and effectively and to determine the correct removal time, it is necessary to apply a layer of as consistent a thickness as possible.After waiting approximately 20 to 30 minutes, the graphic can be easily removed. The processing time is influenced by the film thickness, film type, and age.

CAUTION: IP Vinyl Remover Pro should NOT be left on the vinyl and substrate for LONGER than the recommended 20 to a maximum of 30 minutes (to prevent potential damage to the substrate).

Note: To minimize discoloration, do not apply the product in direct sunlight or on a hot surface. IP Vinyl Remover Pro contains no hazardous ingredients and can be considered environmentally friendly. For best results, allow IP Vinyl Remover Pro to sit on the surface for about 20 minutes before removing the film. A pressure washer or brush can be used to assist with removal.

After the specified application time, immediately clean the surface thoroughly with IP Surface Cleaner or IP Magic Clean and water. Synthetic materials such as Plexiglas, polystyrene, or painted surfaces may be affected.

Caution: Substrates made of polycarbonate and other plastics (e.g., car headlights), synthetically produced substrates such as acrylic, Plexiglas, and polystyrene, rubber and gaskets, as well as any painted substrate, may be affected by IP Vinyl Remover Pro. This is especially true if the substrate is already aged. In such cases, stress cracks may develop on the surface. Therefore, it is recommended that all users of IP Vinyl Remover Pro test it on a small (ideally inconspicuous) area of the substrate to ensure its suitability for the respective surface.

Precautions: Keep away from heat, sparks, flames, and ignition sources, as well as static electricity. Avoid skin and eye contact; wear gloves and safety goggles. Avoid inhaling vapors, mist, or spray. Use only with adequate ventilation. Close the container after each use. Do not ingest and keep out of the reach of children.

First aid recommendations:

• Eye contact: Immediately flush eyes with plenty of water and seek medical attention.
• Skin contact: Remove contaminated clothing and shoes. Immediately wash skin with plenty of water. If symptoms persist, consult a doctor. Be sure to wash contaminated clothing and shoes before reuse.
• Inhalation: Move the person to fresh air. If symptoms occur, seek medical advice.
• If swallowed: Do not induce vomiting; instead, have the person drink two glasses of water if they are conscious. Seek medical attention immediately.